Components of the machine:
3ton manual decoiler……………………………………………………….……………….. 1 unit
Guiding……………………………………………………………………..………………….. 1 unit
Roll former…………………………………………………………………..……………….. 1 unit
Warm Box …………………………………………………………………………….…….. 5 units
Adjusting devices……………………………………………………………………….. 2 units
Pneumatic saw cutting device with servo motor….…………………….. 1 unit
Transfer belt...................................................................................1 unit
Side hole punching device..............................................................1 unit
Hydraulic tank(with servo motor) ………………………………………………1 unit
PLC Control system………………………………………………………………..……….. 1 unit
Run out table (six meters) …………………………………………………………….. 1 unit
Description of the machine:
1- DE-COILER
l Shaft width: 300mm
l Manual shaft opening: 470~530mm
l Weight capacity: 3ton
2- ROLL FORMING MACHINE
l Roller material: GCr15 advanced steel, precision-machined, high frequency quenching HRC58-62
l Shaft Diameter: 65mm
l Forming stations: 26 stations
l Driven: gear box transmission
l Cutting: Pneumatic following cutting, with servo motor
l Working speed: approx. 25~30m/min (with injection and cutting)